hp smart array p410i controller self test failure

Bay's 1 - 8 have: HP 1 TB drives inserted I'm helping an office and they have the following configuration:ĭrive configuration: 8 drives. The logical drive is still not accessible.Hello, I was wondering if I could get some feedback/suggestions regarding a failed RAID hard drive. Physicaldrive 2I:1:6 (port 2I:box 1:bay 6, SATA, 750 GB, OK) Now I replaced the failed drive by hotswapping it with the unassigned drive. Continue? (y/n) yīut as you can see, re-enabling the logicaldrive this was not possible. Warning: Any previously existing data on the logical drive may notīe valid or recoverable. ~# /usr/sbin/hpacucli ctrl slot=0 ld 2 modify reenable So I tried was to reenable the logicaldrive (to add the spare afterwards): I thought maybe the controller put the array into 'failed' state due to the missing spare and protects failed arrays from modification.

Interestingly it is possible to add the unassigned drive to the first array without problems. Use the 'show' command on devices to show additional details ~# /usr/sbin/hpacucli ctrl slot=0 array B add spares=2I:1:8Įrror: This operation is not supported with the current configuration. I first tried to add the unassigned drive 2I:1:8 as a spare to logicaldrive 2, but this was not possible: I noticed the problem due to I/O errors on the host, even if only 1 physicaldrive of the RAID5 is failed.ĭoes someone know why this could happen? The logicaldrive should go into 'Degraded' mode but still be fully accessible from the host os!? I thought that I had drive 2I:1:8 configured as a spare for Array A and Array B, but it seems this was not the case :-(. Physicaldrive 2I:1:8 (port 2I:box 1:bay 8, SATA, 750 GB, OK) Physicaldrive 2I:1:7 (port 2I:box 1:bay 7, SATA, 750 GB, OK) Physicaldrive 2I:1:6 (port 2I:box 1:bay 6, SATA, 750 GB, Failed) Physicaldrive 2I:1:5 (port 2I:box 1:bay 5, SATA, 750 GB, OK) Physicaldrive 1I:1:4 (port 1I:box 1:bay 4, SATA, 750 GB, OK)

Physicaldrive 1I:1:3 (port 1I:box 1:bay 3, SATA, 750 GB, OK) Physicaldrive 1I:1:2 (port 1I:box 1:bay 2, SATA, 750 GB, OK) Physicaldrive 1I:1:1 (port 1I:box 1:bay 1, SATA, 750 GB, OK) Smart Array P400 in Slot 0 (Embedded) (sn: XXXX) ~# /usr/sbin/hpacucli ctrl slot=0 show config This is how it looked when I detected the error: 256 MB Cache/Battery Backup) with a logicaldrive with replaced failed physicaldrive that does not rebuild. I have a HP Server with SmartArray P400 controller (incl.

Hp smart array p410i controller self test failure